DESCRIPTION
HI-DAMPPROOF is a Ready to use a single component for damp proofing of masonry block, Walls, precast and poured concrete foundation walls.
USE
New Construction: Damp proofs and seals residential masonry block and concrete foundation walls.
ADVANTAGES
Can be applied directly to damp walls
Can be applied to the top of foundation walls
Surface cure within 4-6 hours
Can be painted overcoating
Easy to apply by Brush, Roller or Airless spray
Continuous coating eliminates seams
PACKING
HI-DAMPPROOF is packed in 5kg, 10kg, and 20kg Plastic Containers.
TECHNICAL DATA
Color : White
Form : R.F.U
Specific Gravity : 1.25
Bonding : Excellent
Appln Temp : >5º C
Service Temp : 20ºC – 55ºC
Solid Content : >60%
Accelerated Weathering : UV Resistant
APPLICATION
Repair all structural deficiencies before applying a hi-damp proof damp proof coating. Concrete tie locations below grade that create holes or recesses into the wall, shall be sealed with an approved material or method. The surface must be clean, sound, dry and free from oil, grease, laitance and any loose particles to ensure good Adhesion. Where necessary to seal off dust and cohesiveness to improve the substrate, Apply HI-PRIME as a Primer.
Apply two Coats of Hi Damp proof damp proof coating, without dilution with Brush, Roller or airless sprayer. The application should be similar to painting – in one direction. Allow this first coat to dry for about 4-6 hours apply the second coat of the slurry in the direction of right angles of the first coat. The material must be completely dry to the substrate, before any type of protection board is applied or before backfill operations can begin. Equipment cleans with water.